Results 1 to 10 of 156

Thread: Any recommendations internal speaker wire?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #9
    Senior Hostboard Member LowOhms's Avatar
    Join Date
    December 30th, 2012
    Location
    Warrensburg, MO
    Posts
    516
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Re: Any recommendations internal speaker wire?

    Hi GM,

    To twist, or not to twist ??

    It may be " centuries proven " as you suggest, but it is not always the best way to execute it, if one simply listens.

    I have recently been able to listen to wires, twisted and untwisted, and ....in certain applications, ....untwisted sounds better to me . Two specific examples follow :

    (1) In a transparent SET amplifier, the end-to end ( outside wires ) of a power transformer's high voltage secondary windings leads, going to a rectifier tube, sound best if NOT twisted. ( The 5 VCT filament winding to the rectifier tube, however, NEEDS to be twisted. ) I believe there were two people who already independently made such conclusions, Jack Elliano was first - long ago, and recently, Dennis Fraker, both Manufacturers.

    (2) For between power amp to driver runs, I have recently A-Bed this, ( this month ) and on my system, polarities not touching clearly sounds better. In fact, ANYONE would plainly hear this on MY system.

    Although the decades-old EE books denote what AWG works for so many feet, and I appreciate you showing this to us all..... I suggest that their assumptions may need to be questioned, re-evaluated, as being ...not adequate. It ass/u/mes a 10% loss. Is that ....a good assumption??

    My first audio mentor, Robert Fulton had a saying I like a lot " An inch of bad wire can ruin the musical experience ". I agree with him, while at the SAME time, I seek to show absolutely no disrespect to you, and your MANY contributions to ALL of us !!

    I would hope this Forum is " big" enough to allow some diversity of thought. Non touching of polarities, in the two areas I have mentioned herein, ( H.V. winding and amplifier-to-drivers ) were specifically ( and purposefully ) used in the RMAF demo room in 2016 by Serious Stereo, and they will be again, this October 2017.

    To see a photo, taken by the Stereophile magazine reviewer, access the URL below, and look at the photo of the two monaural RED JJ 2A3-40 power amps, and VIEW how all the leads are very carefully orientated !


    RMAF 2016: Sunday at the Show with Herb | Stereophile.com


    I discovered the results of " no touch " in MY system, only about ten days ago, and was ecstatic over the new and positive results. I seek to share that with others. What I HEAR, always trumps any decades-old written theory. If it sounds better, it is better IMHO.

    If you personally A-Bed this, and clearly heard it, what would YOU do and / or think ?? Reality trumps theory. Results matter.

    Respectfully submitted,

    Jeff Medwin.....Low Ohms.
    Last edited by LowOhms; June 28th, 2017 at 06:53 PM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
This forum has been viewed: 27936657 times.